Skip to content

Embroidery time calculator

Work out how long a design takes on your machine, per piece and for the whole order.

The file is read in this tab and never uploaded.

stitches/min

An average speed; enter your machine's own.

Both times depend on your machine; a time left empty is not counted.

Per piece16.3 min

Sewing: 7,619 ÷ 700 stitches/min
10.9 min
Colour changes: 1
not counted
Trims: 0
not counted
Hooping and handling: × 1.5
5.4 min

Total for 24 pieces on 1 headabout 6 h 32 min

How the time is worked out: stitches ÷ speed, plus colour changes and trims at the seconds you enter, times 1.5 with handling on. Each run sews one piece on every head.

Where the starting values come from: 700 stitches/min is the average given by Sewing Machine Fun; stitches ÷ speed is the sum Embroidery Legacy uses; 1.5 × for handling is a shop owner's rule on The Shirt Board forum. No source gives the seconds for a colour change or a trim, so they start empty.

Type the stitch count or read it from the file, put in your speed, pieces and heads, and every part of the time shows beside the result.

Measuring your own numbers

Machine speed is the speed you actually run this kind of design at, not the highest speed on the brochure: small lettering and caps usually run slower than a flat fill. Colour changes and trims cost a few seconds each; time one of each with a stopwatch on your own machine, because the seconds differ a lot between a single-needle machine and a multi-head. Heads sew in parallel: with four heads, 24 pieces take 6 runs.

What the time leaves out

The result is the time the machine and the operator spend on the pieces. It does not include digitizing, a test sew-out, trimming loose threads after sewing, or packing; add those to your quote separately.

Questions

How long does a 10,000 stitch design take?

At 700 stitches a minute the sewing alone takes about 14 minutes. With 1.5 × for hooping and handling it comes to about 21 minutes a piece, so 24 pieces on one head take about 8 h 34 min and on four heads about 2 h 9 min.

Why are the colour change and trim seconds empty?

We found no published figure for them; they depend on the machine, the thread and the operator. Time one colour change and one trim on your own machine and enter the seconds; until then those rows say they were not counted.

What does the 1.5 × handling allowance cover?

Hooping and unhooping, changing the garment, a thread break now and then. It is a rule of thumb from a shop owner, not a measurement; turn it off to see the machine time alone.

Where do I get the stitch count, colour changes and trims?

Read them from the stitch file with the button above; the file is read in your browser and never uploaded. Without a file, the stitch count estimator gives an approximate count from the size.

Your first design is on us.

Upload a logo and see the stitch preview. No card needed.

Upload an image
Stitch preview of the Ridgeview Eagles chest logo